![]() Congratulations, you have successfully programmed your Liftmaster wireless keypad! If the code is accepted, the garage door should open or close accordingly. The LED light will start blinking, indicating that the opener has learned the code from the keypad.įinally, test the keypad by entering the PIN code you just programmed. Immediately after pressing the “enter” or “send” button, go back to the garage door opener and press the “learn” button again. After entering the code, press the “enter” or “send” button on the keypad. This code can be any combination of numbers, but make sure it is something that you will remember. Next, go to the keypad and enter the four-digit PIN code you want to use. You will see a small LED light turn on, indicating that the opener is in programming mode. Once you have found the “learn” button, press and release it. It may be labeled as “learn” or have a small icon that resembles a lock or a light bulb. This button is typically found on the back panel of the opener, near the motor. ![]() The first step is to locate the “learn” button on your Liftmaster garage door opener. If you have a Liftmaster garage door opener and want to program your keypad to work with it, you’re in luck! Programming the keypad with a Liftmaster garage door opener is a straightforward process that can be done in just a few simple steps. Programming the Keypad with a Liftmaster Garage Door Opener ![]() It’s a convenient and secure solution that provides added peace of mind. Now that you’ve successfully set up your Liftmaster Wireless Keypad, you can comfortably enter and exit your garage without the need for keys or a remote control. Just make sure to press the Learn button on the opener unit before entering the new PIN. If you have multiple Liftmaster devices or need to program additional keypads, you can repeat this process for each device. If the keypad is working properly, your garage door should start opening or closing depending on its current state.ĥ. To test the keypad, simply enter your four-digit PIN and press the “Enter” button. This means that the keypad has been set up and is ready to use.Ĥ. After pressing “Enter,” the main garage door opener unit will emit a beep or flash its lights to indicate that the PIN has been successfully programmed into the system. ![]() Be sure to choose a PIN that is easy for you to remember, but difficult for others to guess.ģ. Within 30 seconds of pressing the Learn button, enter your desired four-digit PIN into the keypad and then press the “Enter” button. This button is usually red, yellow, or purple and may have the word “Learn” or “Program” written next to it. Start by locating the Learn button on the back or side of your Liftmaster garage door opener. Follow the instructions below to get your Liftmaster Wireless Keypad up and running.ġ. Setting up the keypad is a simple process that can be done in just a few steps. The Liftmaster Wireless Keypad is a convenient and secure way to access your garage without needing a physical key or remote control. Setting up the Liftmaster Wireless Keypad Troubleshooting Common Issues with the Liftmaster Wireless Keypad.Programming the Keypad with a Liftmaster Garage Door Opener.Setting up the Liftmaster Wireless Keypad.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |